|
Post by gruntfuttock on Feb 6, 2022 5:14:04 GMT
Further to my earlier posting, and following some advice that I had received.
I plugged a guitar directly into my 100W amp on full volume and gain. Pure guitar no “White Noise”
I followed the same procedure for each effect pedal and similar result - until I tried the HCSE. This is where the “White Noise” is coming from. It doesn’t make a difference if all controls are extreme left or right, or if the unit is switched on or not, or which patch is selected. I experience the same “White Noise”
I swopped out the power cable but this made no difference.
I swopped the power supply 12V AC 1000A
I would imagine that there is an internal component on the blink.
Does anyone have any thoughts on the above?
Many thanks Dave
|
|
|
Post by Charlie Hall on Feb 6, 2022 14:45:54 GMT
Hi Dave, I had thought you previously said the noise disappeared when the guitar cable was unplugged. If this is not the case, then it is possible a modification to the output transistor of the HCSE is needed. Stephen at Electromech may be able to assist you with getting it fixed locally. Please contact support@hallandcollins.com for advice on this. Regards, Charlie
|
|
|
Post by gruntfuttock on Feb 7, 2022 5:35:54 GMT
Many thanks Charlie. I ave done as you suggested.
|
|