|
Post by normg on Feb 6, 2015 3:52:14 GMT
Hi guys, my magicstomp is jammed between patches U31 and U33. By operating the footswitch buttons - and + I can only go between the 2 patches. It has been programmed with Charlie's EFTP. It was working normally last time I was using it. Has anybody ideas of fixing this problem. Cheers Norm. PS I have to go out soon plus the time difference here in NZ which will explain if there is a delay in answering questions.
|
|
|
Post by George Lewis on Feb 6, 2015 4:54:37 GMT
Hi Norm, Sounds like the MS is in "Performance Mode" where the +, On/Off, and - switches control 3 adjacent patches rather than Up/Down mode. To return to the normal Up/Down mode just press and hold 2 of the switches until "UP/DOWN MODE" appears on the display. Here is a page from the manual which explains it fully. regards George
|
|
|
Post by normg on Feb 6, 2015 19:49:52 GMT
Hi George, Worked a treat, I was unable to find my Magicstomp manual and didn't want to play around in case I deleted Charlie's patches. Thanks once again. Cheers, Norm
|
|