|
Post by alandunbar on May 3, 2020 11:18:21 GMT
Hi Charlie,
I have one of your units ser.no. 00000232, I haven't used it for a while, so a bit rusty with operating procedures, in the manual, page 7 it says to switch from one bank to the other select a patch before 01 or after 64, before 01 it goes to 64 and vice versa and stays on the same bank.
Any suggestions?
Regards Alan
|
|
|
Post by Charlie Hall on May 3, 2020 12:39:42 GMT
Hi Alan, What you describe is what is supposed to happen, except you didn't mention the patch number being preceded by P or U, denoting a Preset or a User patch. Does this help? Regards, Charlie
|
|
|
Post by alandunbar on May 3, 2020 14:53:56 GMT
Thanks for getting back to me Charlie,
Yes, Iv'e got it now, what I was doing was when I was on patch UO1, I went back to P64 but was then going forward to UO1 again, I now realise that from P64 you have to scroll back to change bank to get PO1.
Many thanks Charlie
Regards Alan
|
|